Ultra Start Automobile Alarm 1250 User Manual

OWNERS GUIDE  
This Manual Covers All 1250 Series  
Remote Vehicle Starters  
U.S.A. Model  
REMOTE STARTERS  
CAR ALARMS  
ü
WWW.ULTRASTARTERS.COM  
FCC/ID Notice  
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:  
(1) This device may not cause harmful interference, and  
(2) This device must accept any interference received, including interference that may cause undesired operation.  
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance void the user’s  
authority to operate this devise.  
-The system must be placed into Service Mode before any service work is started on  
the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done.  
The manufacturer accepts no liability or responsibility for accidental starting of the  
vehicle.  
- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)  
 
Owners Guide  
REMOTE STARTER FEATURES  
Remote Start  
1.Press and release the  
button.  
2.The Park lights will flash and the horn(optional) will honk one time.  
3.When the vehicle has started, the system will flash the park lights four times then remain “On” while  
the vehicle is running.  
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).  
Extended Run Time  
1.Press and release the button while the vehicle is remote started.  
2.The system will respond with one park light flash and one horn honk (optional) to  
confirm Extended Runtime. The system will reset the run time, (normally 15 minutes).  
Remote Stop  
1.Press and hold the button for three seconds. The remote starter will shut down.  
2.The park lights will flash two times and the horn(optional) will honk two times.  
Note: Pressing the brake pedal or opening hood will also stop the vehicle.  
3 sec.  
Idle Mode  
1.While the vehicle is running with key, press the  
button.  
2.The park lights will turn on and the horn(optional) will honk once.  
3.Turn the ignition key “Off” and the vehicle will continue to run.  
4. Exit the vehicle and leave it running safely without the keys in the ignition. Always lock the doors if the  
vehicle is left running.  
While  
running  
Timer Mode. (Starts the vehicle in at a pre-set start interval)  
1.Press and release the # button, then press and hold the  
turn “On” to confirm entering Timer Mode.  
2. Whilethe parklightsareOnthestartcycle canbeselected.  
button for six seconds. The parking lights  
1 hour cycle  
2 hour cycle  
3 hour cycle  
4 hour cycle  
Press LOCK  
button  
Press UNLOCK button  
1 Park Light Flash  
2 Park Light Flashes  
3 Park Light Flashes  
4 Park Light Flashes  
1st  
2nd-6 sec  
Press  
Press  
button  
button  
#
3. The system will start the vehicle at the selected start cycle. The vehicle will run for it’s runtime then  
shut off. The system will repeat this for a maximum 24 hour period.  
TO CANCEL TIMER MODE  
1. Press and release the # button, then press and hold the  
button for four seconds.  
2. The System will respond with two flashes and two horn honks (optional).  
3. Starting the vehicle with the key or by remote will also disable Timer Mode.  
Diagnostics  
PARK LIGHTS  
3 Flashes  
3 Slow Flashes  
4 Slow Flashes  
5 Flashes  
5 Slow Flashes  
6 Flashes  
7 Flashes  
STATUS LED  
Series of 3 Flashes  
LED’s On Solid  
Series of 4 Flashes  
Series of 5 Flashes  
Series of 5 Flashes  
Series of 6 Flashes  
Series of 7 Flashes  
Series of 8 Flashes  
DIAGNOSTIC CODE  
Door Opened “M” Models  
System Is In Service Mode  
Not in Reservation Mode “M” units  
Brake Pedal Shutdown  
Ignition On During Start Attempt  
Hood Pin Grounded  
Tach Lock-Out  
8 Flashes  
3 Start Attempts with no start  
 
ATTENTION: THE SYSTEM MUST BE PLACED INTO SERVICE MODE BEFORE ANY UNDER HOOD  
SERVICING IS DONE TO THE VEHICLE. IT IS THE RESPONSIBILITY OF THE VEHICLE’S OWNER TO  
INSURE THAT THIS IS DONE. THE MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR  
ACCIDENTAL STARTING WHILE VEHICLE IS BEING SERVICED.  
Remote Service Mode (Valet Mode)  
Service Mode disables the remote starter from operating. It will be necessary to activate  
Service Mode when having the vehicle serviced.  
ENTERING SERVICE MODE  
1.Press and release the # button, then within two seconds press and hold the same # button  
for five seconds or until the horn(optional) honks five times. The LED’s on the antenna will  
come “On” and then stay on solid to confirm that the system is in Service Mode.  
1st - ½ sec  
2nd - 5 sec  
EXITING SERVICE MODE  
1.Press and release the # button, then within two seconds press and hold the same # button  
for five seconds or until horn(optional) honks two times.  
Note: If the remote start button is pressed when the system is in Service Mode the park  
lights will flash 3 times. Remote start and Alarm functions will be disabled and the  
LED‘s will be “On”Solid. The door locks and the trunk release will still be operational.  
Emergency Service Mode (Valet Mode)  
This feature will disable the system except for locking and unlock functions.  
This mode can also used if a remote is lost, damaged or if the system malfunctions.  
ENTERING SERVICE MODE  
1.While the ignition is “On” press and hold the Program Button for 5 seconds or until the horn (optional)  
honks five times.  
EXITING SERVICE MODE  
Ignition  
“On”  
1.While the ignition is “On” press and hold the Program Button for 5 seconds or until the horn (optional)  
honks two times.  
5 sec.  
Note: Remote starter functions will be disabled and the LED will be “On” steady.  
The door locks and the trunk release will still be operational.  
WARRANTY  
The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from defects  
in material and workmanship. However, should this product be proven to be defective, within a two year period from the original  
date of purchase, the manufacturer will, without charge to the purchaser (excluding any charges incurred to have the product  
delivered to the manufacturer) , repair or replace any part of the remote starter and/or alarm which the manufacturer agrees to be  
defective. All warranties apply on to the original purchaser and the vehicle in which it is originally installed. Repairs or replacement  
of defective modules shall remain at the discretion of the manufacturer. All other parts, components, accessories and/or optional  
equipment pertaining to the remote starter and alarm are not included in the manufacturer’s warranty. This warranty is non-  
transferable. Request for warranty service from any Factory Authorized Dealer must be accompanied with the original  
purchase receipt or have product registered by authorized dealer on manufacturer’s website. Failure to comply with any of  
these conditions may result in warranty being voided.  
This warranty does not cover the following: removal and reinstall labour charges, shipping charges, abuse, misuse, or accidental  
damages to the remote starter and alarm, automobile, and/or parts there of. This warranty is void upon modification, repairs, or  
alterations of any part of the System. The manufacturer does not guarantee or insure against theft of the vehicle or its contents.  
Alarm models are designed only to act as a deterrent against possible theft. This alarm may qualify for auto insurance discounts,  
contact your Insurance Agent for further information . The manufacturer shall not be held liable for any consequential damages due  
to breach of this or any other warranty, expressed, or implied. This warranty gives you specific legal rights. Your specific legal  
rights may vary for each region.  
CERTAIN DAMAGES EXCLUDED - The manufacturer expressly disclaims any liability or responsibility for incidental damages  
caused by the product, including economic loss, loss of use of the product, car rentals, or any other costs relating to the care and  
custody of the product. The manufacturer disclaims liability or responsibility for any consequential damages caused by the product  
or resulting from its use, including the cost of repairing or replacing other property damaged by the product or caused by its use,  
whether or not the product is working properly. The product is intended to deter unauthorized use of the vehicles in which it is  
installed. The manufacturer does not warrant that the product is fool-safe against theft and/or vandalism and/or human error or  
misuse. The manufacturer accepts no liability or responsibility for any damage of any kind whatsoever caused to any vehicle in  
which the product is installed or any resulting damage from its use. The manufacturer accepts no responsibility or liability for any  
damage resulting to or theft of the vehicle or its contents, caused or alleged to be caused, directly or indirectly, by failure of the  
product.  
 

Texas Instruments Calculator TI 84 User Manual
Timex Watch Performance Watch User Manual
TOA Electronics Network Cables NX 100 User Manual
Toshiba Power Supply REMOTE D User Manual
Toshiba Security Camera 3cmos camera head User Manual
Toshiba TV Antenna L1460UC Series User Manual
Tricity Bendix Clothes Dryer TM 551 User Manual
Tripp Lite TV Cables N820 02M User Manual
ViewSonic Projector VS13783 User Manual
Vivotek Security Camera 72P User Manual